Midtown Timber Shaker

Width 96"

Extra large cove crown molding. When installed, it will be 5-1/2" high and will stick out from the cabinet 5-1/2".

Width 96"

Large cove crown molding. When installed, it will be 4-1/2" high and will stick out from the cabinet 4-1/2".

Width 96" | Height 6" | Depth .75"

Molding extension that is used with starter molding (SKU: STRM-8) to make it easier to install molding on the tops of cabinets. The molding extension can be used without the starter molding, but it would first need a cleat support installed on site.

Width 96" | Height 6" | Depth .75"

Shiplap interlocking molding commonly used for walls, backsplash, or the backs of islands and peninsulas.

Width 96" | Height .75" | Depth 2.5"

Stacking molding to be used as a decorative piece between cabinets that are getting stacked one above the other. This hides the 'cabinet seam' that you would normally see without a decorative molding in between or applied over the seam.

Width 96" | Height .75" | Depth 1.5"

Starter molding that is installed above wall and tall cabinets which acts as a cleat for a molding extension (SKU: MEX-8), to make it easier to mount moldings on top of the cabinets. The starter molding and molding extension are ideal to use when mounting crown molding all the way to the ceiling.

Width 6" | Height 34.5" | Depth 24"

Appliance end panel with a 6" stile on the front. Can be trimmed down to 1" wide if necessary. Panel is 1/2" thick plywood.

Width 6" | Height 30" | Depth 24"

Spice pull out to be used with a 6x30 filler (sold separately - see SKU WF630). It comes with chrome rails and full extension, ball bearing glides (not soft-close). It will have 3 adjustable shelves and is constructed of UV coated maple wood. The pullout must be installed between 2 cabinets and the 6" filler (SKU WF630) must be ordered separately. An additional overlay or decorative filler can be installed on the 6" filler if desired (also sold separately).

Width 6" | Height 30" | Depth .75"

Filler, with both long edges finished.

Width 6" | Height 30" | Depth 24"

Spice pull out to be used with a wall filler (sold separately). It comes with chrome rails and full extension, ball bearing glides (not soft-close). It will have 3 adjustable shelves and is constructed of UV coated maple wood. The pullout must be installed between 2 cabinets and the 6" wall filler must be ordered separately.

Width 6" | Height 30" | Depth 12"

Wine cube cabinet made of veneer plywood with wood edge banding. There are 5 cubes that will have finished interiors.

Width 6" | Height 36" | Depth .75"

Wall filler. Both long sides of the filler are finished.