Midtown Timber Shaker

Width 96" | Height 6" | Depth .75"

Molding extension that is used with starter molding (SKU: STRM-8) to make it easier to install molding on the tops of cabinets. The molding extension can be used without the starter molding, but it would first need a cleat support installed on site.

Width 96" | Height 6" | Depth .75"

Shiplap interlocking molding commonly used for walls, backsplash, or the backs of islands and peninsulas.

Width 96" | Height .75" | Depth 2.5"

Stacking molding to be used as a decorative piece between cabinets that are getting stacked one above the other. This hides the 'cabinet seam' that you would normally see without a decorative molding in between or applied over the seam.

Width 96" | Height .75" | Depth 1.5"

Starter molding that is installed above wall and tall cabinets which acts as a cleat for a molding extension (SKU: MEX-8), to make it easier to mount moldings on top of the cabinets. The starter molding and molding extension are ideal to use when mounting crown molding all the way to the ceiling.

Width 30" | Height 6" | Depth 12"

Organizer cabinet with wood veneer edge banding and a finished interior. There will be 2 horizontal shelving areas on the left which measure approximately 11-1/8"W x 2"H, and 3 vertical storage areas on the right which measure approximately 5-1/4"W x 4-3/4"H.

Width 30" | Height 6" | Depth 12"

Organizer cabinet with wood veneer edge banding and a finished interior. There will be 2 horizontal shelving areas on either end which measure approximately 11-1/8"W x 2"H, and 2 vertical storage areas in the middle which measure approximately 5-1/4"W x 4-3/4"H.

Width 96" | Height .75" | Depth .75"

Inside corner molding.

Width 96" | Height .75" | Depth 1.5"

Light rail molding, overall depth is 1-1/2", the flat part that will install under the wall cabinets is 3/4" deep. The lip that will extend over the front of the wall cabinet is 1/4" high.

Width 96" | Height .75" | Depth .75"

Quarter round molding.

Width 96" | Height .75" | Depth .75"

Outside corner molding. Inside height and depth is 5/8".

Width 37-3/4" | Height 46" | Depth 19-7/8"

Artisan style wood hood that comes with a stainless steel liner. The chimney height can be trimmed up to 12" on site, if needed. Blower is not included and would need to be purchased separately. The chimney depth is 9-1/2" and the width is 17".

Width 43-3/4" | Height 46" | Depth 19-7/8"

Artisan style wood hood that comes with a stainless steel liner. The chimney height can be trimmed up to 12" on site, if needed. Blower is not included and would need to be purchased separately. The chimney depth is 9-1/2" and the width is 23".