Midtown Indigo Shaker

Width 13-3/4" | Height 16" | Depth 21"

Trash pull-out for a 18" or 21" base cabinet (two 29 quart waste baskets included). Trash pullout will be a natural finish and will not be pre-installed in cabinet (cabinet must be ordered separately). Includes door mounting kit and full extension, soft-closing glides.

Width 96" | Height 5.5" | Depth .75"

Straight valance.

Width 96" | Height 5.25" | Depth .625"

Base board molding. Please note this base molding is slightly taller to account for uneven flooring and may need to have the height cut if needed, on site.

Width 96" | Height " | Depth 1.25"

Large batten molding.

Width 96" | Height " | Depth .75"

Small batten molding.

Width 96" | Height 1.25" | Depth .375"

Decorative scribe molding. Flat front section is 3/4" high.

Width 96"

Extra large cove crown molding. When installed, it will be 5-1/2" high and will stick out from the cabinet 5-1/2".

Width 96" | Height .75" | Depth .75"

Inside corner molding.

Width 96"

Large cove crown molding. When installed, it will be 4-1/2" high and will stick out from the cabinet 4-1/2".

Width 96"

Large crown molding, when installed, it will be 3-3/8" high and will stick out from the cabinet 3".

Width 96" | Height .75" | Depth 1.5"

Light rail molding, overall depth is 1-1/2", the flat part that will install under the wall cabinets is 3/4" deep. The lip that will extend over the front of the wall cabinet is 1/4" high.

Width 96" | Height 6" | Depth .75"

Molding extension that is used with starter molding (SKU: STRM-8) to make it easier to install molding on the tops of cabinets. The molding extension can be used without the starter molding, but it would first need a cleat support installed on site.