Midtown Cloud Shaker

Width .75" | Height 96" | Depth 24"

Refrigerator end panel. Both 96" sides are edge-banded.

Width .75" | Height 96" | Depth 30"

Refrigerator end panel. Both 96" sides are edge-banded.

Width 48" | Height 34.5" | Depth 24"

2 door base cabinet with 1 three quarter depth adjustable shelf and 2 drawers. This cabinet will have a 2-5/8" center stile.

Width 48" | Height 34.5" | Depth 24"

1 door blind base corner cabinet with 1 drawer and 1 shelf. This cabinet can be placed all the way in the corner (without any pull) so it would take up 48" of wall space. It can be pulled a max of 3", taking up 51" of wall space. The door width is 21-1/4", the stile width is 7-3/8" and the blind opening width is 18-3/4". A filler must be used between the blind and the adjacent cabinet so the doors and drawers are able to open without interference. The filler must be purchased separately.

Width 48" | Height 96" | Depth .25"

Back panel that is made of 1/4" thick MDF. Only 1 side will be finished, all edges and opposite side will be unfinished.

Width 48" | Height 96" | Depth .75"

Back panel that is made of 3/4" thick plywood. Only 1 side will be finished, all edges and opposite side will be unfinished.

Width .75" | Height 96" | Depth 30"

Refrigerator panel that has a 1-1/2" return.

Width .75" | Height 96" | Depth 30"

Refrigerator panel that has a 3" return.

Width 48" | Height 12" | Depth .75"

Arched recessed panel valance that can be trimmed up to 3" on each side.

Width 3/4" | Height 34.5" | Depth 24"

Appliance end panel that finished on two sides and edge-banded on 2 vertical (34-1/2€) edges, there will not be a front stile on this panel.

Width 48" | Height 96" | Depth .5"

Back panel that is made of 1/2" thick plywood. Only 1 side will be finished, all edges and opposite side will be unfinished.

Width 48" | Height 30" | Depth 21"

Arched wood hood with an overall depth of 21", the depth of the main part of the hood (which goes against the wall) is 15". The top panel will lift up and the sides will be flush. If crown is being installed, it would be installed above the cabinet, not on the face frame. A full interior stainless steel hood liner will also be installed (liner can be removed on site, if needed, however a hood liner is strongly recommended to prevent the wood hood from getting burned and is required by code in many places. The interior hood liner dimensions are as follows:

• Rear width: 46-1/2€
• Front width: 41-7/8€
• Depth of 34-1/2€ section: 13-3/4€
• Depth of 29-7/8€ section: 4-1/2€€
• Max fan size: 46-1/2€ x 13-3/4€
• Note that a blower is not included and must be purchased separately