Stone Grey

Width 42" | Height 96" | Depth .75"

Plywood edge banded panel that is trimmable, if needed. The grain (for stained collections) will run along the long side of the panel.

Width 3" | Height 42" | Depth 1.375

Split corner decorative leg that is 3" wide, 42" high and 1-3/8" deep. The top flat section is 7" high and the bottom flat section is 7-1/4" high.

Width 42" | Height 34.5" | Depth 24"

2 door base cabinet that has 1 half depth adjustable shelf and 2 drawers. This cabinet does have a center stile and will not have butt doors.

Width 3" | Height 34.5" | Depth 24"

Base end panel that has a 1/2" thick panel with a 3" wide filler on the front. Can be installed on the left or right. Commonly used next to an exposed appliance, like a dishwasher.

Width 3" | Height 34.5" | Depth .75"

Base filler that is 3/4" thick and can be trimmed to desired height/width. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 3" | Height 34.5" | Depth .75"

Base fluted filler that is 3/4" thick and can be trimmed to desired height. Filler has 3 flutes that begin 1.5" from the top and end 1.5" from the bottom. The toe kick area is not fluted. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 42" | Height 2-1/2" | Depth 10"

Floating shelf that can be installed as floating or between two cabinets or between one cabinet and a wall. The shelf will be finished to match on the front, sides, top and bottom. The maximum load is 15 lbs per linear foot. *Please note that the floating shelves are not trimmable.*

Width 42" | Height 34.5" | Depth 21"

Vanity sink base cabinet that has 1 door on the right, 2 functioning deep drawers on the left and 2 fake drawer fronts across the top. There are no shelves.

Width 42" | Height 34.5" | Depth 21"

Vanity sink base cabinet that has 1 door on the left, 2 functioning deep drawers on the right and 2 fake drawer fronts across the top. There are no shelves.

Width 3" | Height 42" | Depth .75"

Wall filler that is 3/4" thick and can be trimmed to desired height/width. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 3" | Height 96" | Depth .75"

Wall filler that is 3/4" thick and can be trimmed to desired height/width. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 3" | Height 42" | Depth .75"

Wall fluted filler that can be trimmed to desired height and has 3 flutes that begin 1.5" from the top and end 1.5" from the bottom. This filler will be finished on the front, back and sides, but not the top or bottom.