Stone Grey

Width 30" | Height 30" | Depth -

Set of glass doors for a 30"W x 30"H wall cabinet that will match the door style of the cabinet and has clear glass. The glass is also included.

Width 30" | Height 36" | Depth -

Set of glass doors for a 30"W x 36"H wall cabinet that will match the door style of the cabinet and has clear glass. The glass is also included.

Width 30" | Height 42" | Depth -

Set of glass doors for a 30"W x 42"H wall cabinet that will match the door style of the cabinet and has plain glass. The glass is also included.

Width 30" | Height 15" | Depth -

Plate rack that holds 10 plates and can also be installed under a shorter wall cabinet.

Width 30" | Height 23.5" | Depth 8"

Range hood front that must be installed between 2 cabinets for support. Before installation of the range hood front, the blower should be installed and the depth adjusted using fillers and/or panels to fit the blower. The sides will be pre-finished to match.

Width 3" | Height 42" | Depth 1.375

Split corner decorative leg that is 3" wide, 42" high and 1-3/8" deep. The top flat section is 7" high and the bottom flat section is 7-1/4" high.

Width 30" | Height 34.5" | Depth 24"

2 drawer base cabinet with 2 equal sized deep drawers.

Width 30" | Height 34.5" | Depth 24"

2 door base cabinet that has a half depth adjustable shelf and 2 drawers.

Width 48" | Height 34.5" | Depth 24"

2 door base cabinet that has 1 half depth adjustable shelf and 2 drawers. This cabinet does have a center stile and will not have butt doors.

Width 48" | Height 96" | Depth 3/8"

Beadboard panel that can is trimmable, if needed. The grain (for stained collections) will run along the long side of the panel.

Width 3" | Height 34.5" | Depth 24"

Base end panel that has a 1/2" thick panel with a 3" wide filler on the front. Can be installed on the left or right. Commonly used next to an exposed appliance, like a dishwasher.

Width 3" | Height 34.5" | Depth .75"

Base filler that is 3/4" thick and can be trimmed to desired height/width. This filler will be finished on the front, back and sides, but not the top or bottom.