Rustic Shaker

Width 13-3/4" | Height 16" | Depth 21"

Trash pull-out for a 18" or 21" base cabinet (two 29 quart waste baskets included). Trash pullout will be a natural finish and will not be pre-installed in cabinet (cabinet must be ordered separately). Includes door mounting kit and full extension, soft-closing glides.

Width 60" | Height 34.5" | Depth 21"

Vanity combination cabinet that has 2 sets of doors on either side of the cabinet, 3 drawers in the middle, and a fake drawer front on top of each set of doors. The top drawer is standard sized and the bottom 2 drawers are deep drawers. The 3 middle drawers are fully functioning and there are no shelves.

Width 96" | Height 9/16" | Depth .25"

Rope insert for crown molding (LCM8) that comes in 8 ft long sections. There is a flat section on the crown to accommodate the rope insert installation. If it seems the rope insert will not attach properly, make sure the crown is not upside down.

Width 96" | Height .75" | Depth .25"

Shoe molding that can be trimmed to desired height and/or width.

Width 96" | Height 0.75" | Depth 0.25"

Scribe molding that comes in 8 ft long sections. It can be used behind light rail molding when wrapping around the side of a wall cabinet.

Width 36" | Height 96" | Depth .25"

1/4" thick stained panel. Grain runs up and down if the panel is stood up tall (making it 96" high and 36" wide). This panel comes finished on one side.

Width 3" | Height 96" | Depth .75"

Base filler that is 3/4" thick and can be trimmed to desired height/width and has toe kick notch on bottom. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 3" | Height 96" | Depth .75"

Base fluted filler that is 3/4" thick and can be trimmed to desired height. Filler has 3 flutes that begin 1.5" from the top and end 1.5" from the bottom. The toe kick area is not fluted. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 96" | Height 4.5" | Depth .25"

Toe kick that comes in 8' long sections and can be cut to size if necessary.

Width 23.25" | Height 96" | Depth .25"

Tall skin that is 1/4" thick and can be cut to size if necessary. *Please note actual width is 23-1/4"*

Width 3" | Height 34.5" | Depth .75"

Base filler that is 3/4" thick and can be trimmed to desired height/width. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 6" | Height 34.5" | Depth .75"

Base filler that is 3/4" thick and can be trimmed to desired height/width. This filler will be finished on the front, back and sides, but not the top or bottom.