Rustic Shaker

Width 36" | Height 24" | Depth 24"

Wall refrigerator cabinet that has 2 doors and 1 adjustable, full depth shelf.

Width 36" | Height 23.5" | Depth 8"

Range hood front that must be installed between 2 cabinets for support. Before installation of the range hood front, the blower should be installed and the depth adjusted using fillers and/or panels to fit the blower. The sides will be pre-finished to match.

Width 36" | Height 34.5" | Depth 24"

Sink base cabinet that has no shelves or drawers.

Width 3" | Height 42" | Depth 1.375

Split corner decorative leg that is 3" wide, 42" high and 1-3/8" deep. The top flat section is 7" high and the bottom flat section is 7-1/4" high.

Width 36" | Height 96" | Depth .25"

1/4" thick stained panel. Grain runs up and down if the panel is stood up tall (making it 96" high and 36" wide). This panel comes finished on one side.

Width 3" | Height 96" | Depth .75"

Base filler that is 3/4" thick and can be trimmed to desired height/width and has toe kick notch on bottom. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 3" | Height 96" | Depth .75"

Base fluted filler that is 3/4" thick and can be trimmed to desired height. Filler has 3 flutes that begin 1.5" from the top and end 1.5" from the bottom. The toe kick area is not fluted. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 36" | Height 34.5" | Depth 24"

2 drawer base cabinet with 2 equal sized deep drawers.

Width 21" | Height 34.5" | Depth 24"

1 door base cabinet that has a half depth adjustable shelf and 1 drawer.

*Please note that new cabinet inventory (hinged on either the left or right), is going to be replacing the current 'universal' cabinet inventory. During this transition period, if a Left or Right option for this cabinet is selected, but not yet available, you will receive one of the universal bases, which can be hinged either Left or Right, after delivery, on site.*

Width 36" | Height 34.5" | Depth 24"

2 door base cabinet that has a half depth adjustable shelf and 2 drawers.

Width 36" |Height 34.5" |Depth 24"

Blind corner base cabinet that must be pulled a minimum of 4" from the wall. It may be necessary to pull further to allow clearance for door and drawer hardware. It can be pulled a maximum of 9". The door is 14-1/2"W, and the blind area is 22"W x 28-1/2"H. A filler will be needed to go adjacent to the blind cabinet so the door/drawer will open properly.

Width 3" | Height 34.5" | Depth 24"

Base end panel that has a 1/2" thick panel with a 3" wide filler on the front. Can be installed on the left or right. Commonly used next to an exposed appliance, like a dishwasher.