Cobblestone Grey

Width 13-3/4" | Height 16" | Depth 21"

Trash pull-out for a 18" or 21" base cabinet (two 29 quart waste baskets included). Trash pullout will be a natural finish and will not be pre-installed in cabinet (cabinet must be ordered separately). Includes door mounting kit and full extension, soft-closing glides.

Width 60" | Height 34.5" | Depth 21"

Vanity combination cabinet that has 2 sets of doors on either side of the cabinet, 3 drawers in the middle, and a fake drawer front on top of each set of doors. The top drawer is standard sized and the bottom 2 drawers are deep drawers. The 3 middle drawers are fully functioning and there are no shelves.

Width 96" | Height 1-21/32" | Depth .25

Batten molding that comes in 8 ft long sections and is 0.25" thick.

Width 23.25" | Height 34.5" | Depth .25"

Base skin that is 1/4" thick and can be cut to size if necessary. *Please note actual width is 23-1/4"*

Width 96" | Height 9/16" | Depth .25"

Rope insert for crown molding (LCM8) that comes in 8 ft long sections. There is a flat section on the crown to accommodate the rope insert installation. If it seems the rope insert will not attach properly, make sure the crown is not upside down.

Width 96" | Height .75" | Depth .25"

Shoe molding that can be trimmed to desired height and/or width.

Width 96" | Height 0.75" | Depth 0.25"

Scribe molding that comes in 8 ft long sections. It can be used behind light rail molding when wrapping around the side of a wall cabinet.

Width 36" | Height 96" | Depth .25"

1/4" thick stained panel. Grain runs up and down if the panel is stood up tall (making it 96" high and 36" wide). This panel comes finished on one side.

Width 96" | Height 4.5" | Depth .25"

Toe kick that comes in 8' long sections and can be cut to size if necessary.

Width 23.25" | Height 96" | Depth .25"

Tall skin that is 1/4" thick and can be cut to size if necessary. *Please note actual width is 23-1/4"*

Width 30" | Height 7.5" | Depth 21"

Under counter/knee drawer that can be bumped out with 2x4's if being used with 24" deep cabinets. This is designed to be installed under counter to create a desk area between either vanity cabinets (21" depth) or standard base cabinets (24" depth). The overall width is 30" which can be trimmed if necessary (up to 1-1/2" on each side). Actual drawer front width is about 24".

Width 36" | Height 7.5" | Depth 21"

Under counter/knee drawer that can be bumped out with 2x4's if being used with 24" deep cabinets. This is designed to be installed under counter to create a desk area between either vanity cabinets (21" depth) or standard base cabinets (24" depth). Overall width is 36" which can be trimmed if necessary. Actual drawer front width is about 30".