Tuscan Timber

Width 17" | Height 18" | Depth 12"

Appliance garage with a front width of 17". It will have a roll up, tambour door and is designed to fit under a 24x24 diagonal corner wall cabinet. The door opening is approximately 14" wide, the tambour door is partially inserted into the frame on either side.

Width 96" | Height 1.25" | Depth 1.25"

Outside corner molding. Inside height and depth is 7/8".

Width 3" | Height 96" | Depth .75"

Tall filler. The 2 long sides of the filler will be finished.

Width 3" | Height 34.5" | Depth 24"

Appliance end panel with a 3" stile on the front. Can be trimmed down to 1" wide if necessary. Panel is 1/2" thick plywood.

Width 96"

Small cove molding, when installed, it will be 2-1/8" high and will stick out from the cabinet 2-1/8".

Width 96"

Cove crown molding, when installed, it will be 2-1/2" high and will stick out from the cabinet 2-7/8".

Width 96" | Height .75" | Depth 1.5"

Light rail molding, overall depth is 1-1/2", the flat part that will install under the wall cabinets is 3/4" deep. The lip that will extend over the front of the wall cabinet is 1/4" high.

Width 96"

Large crown molding, when installed, it will be 3-3/8" high and will stick out from the cabinet 3".

Width 96" | Height 5.25" | Depth .625"

Base board molding. Please note this base molding is slightly taller to account for uneven flooring and may need to have the height cut if needed, on site.

Width 3" | Height 96" | Depth 24"

Refrigerator end panel with 3" stile on the front. The panel itself is 3/4" thick.

Width 3" | Height 30" | Depth .75"

Filler, with both long edges finished.

Width 3" | Height 36" | Depth .75"

Wall filler. Both long sides of the filler are finished.