Tuscan Painted Grey

Width 96"

Extra large cove crown molding. When installed, it will be 5-1/2" high and will stick out from the cabinet 5-1/2".

Width 96"

Large cove crown molding. When installed, it will be 4-1/2" high and will stick out from the cabinet 4-1/2".

Width 96" | Height 6" | Depth .75"

Molding extension that is used with starter molding (SKU: STRM-8) to make it easier to install molding on the tops of cabinets. The molding extension can be used without the starter molding, but it would first need a cleat support installed on site.

Width 96" | Height 6" | Depth .75"

Shiplap interlocking molding commonly used for walls, backsplash, or the backs of islands and peninsulas.

Width 96" | Height .75" | Depth 2.5"

Stacking molding to be used as a decorative piece between cabinets that are getting stacked one above the other. This hides the 'cabinet seam' that you would normally see without a decorative molding in between or applied over the seam.

Width 96" | Height .75" | Depth 1.5"

Starter molding that is installed above wall and tall cabinets which acts as a cleat for a molding extension (SKU: MEX-8), to make it easier to mount moldings on top of the cabinets. The starter molding and molding extension are ideal to use when mounting crown molding all the way to the ceiling.

Width 48" | Height 96" | Depth .5"

Back panel that is made of 1/2" thick plywood. Only 1 side will be finished, all edges and opposite side will be unfinished.

Width 48" | Height 96" | Depth .25"

Back panel that is made of 1/4" thick MDF. Only 1 side will be finished, all edges and opposite side will be unfinished.

Width 48" | Height 96" | Depth .75"

Back panel that is made of 3/4" thick plywood. Only 1 side will be finished, all edges and opposite side will be unfinished.

Width 48" | Height 34.5" | Depth 24"

1 door blind base corner cabinet with 1 drawer and 1 shelf. This cabinet can be placed all the way in the corner (without any pull) so it would take up 48" of wall space. It can be pulled a max of 3", taking up 51" of wall space. The door width is 21-1/4", the stile width is 7-3/8" and the blind opening width is 18-3/4". A filler must be used between the blind and the adjacent cabinet so the doors and drawers are able to open without interference. The filler must be purchased separately.

Width 48" | Height 12" | Depth .75"

Arched recessed panel valance that can be trimmed up to 3" on each side.

Width 48" | Height 30" | Depth 21"

Arched wood hood with an overall depth of 21", the depth of the main part of the hood (which goes against the wall) is 15". The top panel will lift up and the sides will be flush. If crown is being installed, it would be installed above the cabinet, not on the face frame. A full interior stainless steel hood liner will also be installed (liner can be removed on site, if needed, however a hood liner is strongly recommended to prevent the wood hood from getting burned and is required by code in many places. The interior hood liner dimensions are as follows:

• Rear width: 46-1/2”
• Front width: 41-7/8”
• Depth of 34-1/2” section: 13-3/4”
• Depth of 29-7/8” section: 4-1/2””
• Max fan size: 46-1/2” x 13-3/4”
• Note that a blower is not included and must be purchased separately