Milan Hazel

Width 13-3/4" | Height 16" | Depth 21"

Trash pull-out for a 18" or 21" base cabinet (two 29 quart waste baskets included). Trash pullout will be a natural finish and will not be pre-installed in cabinet (cabinet must be ordered separately). Includes door mounting kit and full extension, soft-closing glides.

Width 96" | Height 4-1/2" | Depth 3/4"

Base board molding that is edge banded on all 4 edges.

Width 3" | Height 30" | Depth 3/4"

Base filler that comes as a flat panel and will not have a toe-kick recessed area on the bottom. It will be finished on two sides and edge-banded on all four edges.

Width 6" | Height 30" | Depth 3/4"

Base filler that comes as a flat panel and will not have a toe-kick recessed area on the bottom. It will be finished on two sides and edge-banded on all four edges.

Width 33" | Height 30" | Depth 21"

Easy reach corner cabinet that will take up 33" from the corner out, on each wall. It comes with one adjustable shelf and will not have soft close hinges. The cabinet will have a 21" depth for an easier installation, however due to the smaller depth, it must be pulled out 3" off both walls (thus, taking up 24" of wall space on each wall). This gap will not be visible once countertops are installed. Once assembled, the door cannot be reversed, so be sure to specify left or right hinging (as if facing the cabinet). Black, adjustable, plastic furniture feet will also be included which will add 3-3/4" to 5-3/8" to the 30" height.

Width 36" | Height 30" | Depth 21"

Easy reach corner cabinet that will take up 33" from the corner out, on each wall. It comes with one adjustable shelf and will not have soft close hinges. The cabinet will have a 21" depth for an easier installation, however due to the smaller depth, it must be pulled out 3" off both walls (thus, taking up 24" of wall space on each wall). This gap will not be visible once countertops are installed. Once assembled, the door cannot be reversed, so be sure to specify left or right hinging (as if facing the cabinet). Black, adjustable, plastic furniture feet will also be included which will add 3-3/4" to 5-3/8" to the 30" height.

Width 30" | Height 30" | Depth 21"

Farm sink base cabinet. Door heights are 17-7/8". Typically, the farm sink base should be a minimum of 3" wider than the farm sink (for example, a 30" farm sink would need a 33" farm sink base). The front panel is attached with clips for easy removal and install. Once removed, the opening will need to be cut, the maximumum it can be cut is 28-1/2"W x 11-5/8"H, then the panel will be reattached back onto the cabinet. To avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off). Black, adjustable, plastic furniture feet will also be included which will add 3-3/4" to 5-3/8" to the 30" height.

Width 33" | Height 30" | Depth 21"

Farm sink base cabinet. Door heights are 17-7/8" and the height above the doors to the top of the cabinet is 11-7/8". Typically, the farm sink base should be a minimum of 3" wider than the farm sink (for example, a 30" farm sink would need a 33" farm sink base). The front panel is attached with clips for easy removal and install. Once removed, the opening will need to be cut, the maximumum it can be cut is 31-1/2"W x 11-5/8"H, then the panel will be reattached back onto the cabinet. To avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off). Black, adjustable, plastic furniture feet will also be included which will add 3-3/4" to 5-3/8" to the 30" height.

Width 36" | Height 30" | Depth 21"

Farm sink base cabinet. Door heights are 17-7/8" and the height above the doors to the top of the cabinet is 11-7/8". Typically, the farm sink base should be a minimum of 3" wider than the farm sink (for example, a 30" farm sink would need a 33" farm sink base).The front panel is attached with clips for easy removal and install. Once removed, the opening will need to be cut, the maximumum it can be cut is 34-1/2"W x 11-5/8"H, then the panel will be reattached back onto the cabinet. To avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off). Black, adjustable, plastic furniture feet will also be included which will add 3-3/4" to 5-3/8" to the 30" height.

Width 36" | Height 30" | Depth 21"

Heat shield that is 1/16" thick powder-coated steel, with pre-drilled installation holes. It will need to be cut to size and must be used on either side of a range base cabinet to shield the adjacent cabinet boxes from the oven heat (also recommended to be used on either side of a range top). Sold in quantities of 1, a quantity of 2 must be ordered to received 2 heat shields.

Width 96" | Height 1-1/2" | Depth 3/4"

Light rail molding that must be used with the starter molding (STRM-8) to be flush with the front of the cabinet doors.

Width 33" | Height 30" | Depth 21"

Lazy susan base cabinet that will take up 33" from the corner out, on each wall. Both wooden Lazy Susan trays rotate independently and the center tray is mounted on a 3/4" adjustable shelf. This cabinet cannot use a soft close hinge. Each bi-fold door is 9" wide. It is designed to have a smaller footprint for ease of installation (which is why the depth is 21"). Black, adjustable, plastic furniture feet will also be included which will add 3-3/4" to 5-3/8" to the 30" height.