Milan Hazel

Width 13-3/4" | Height 16" | Depth 21"

Trash pull-out for a 18" or 21" base cabinet (two 29 quart waste baskets included). Trash pullout will be a natural finish and will not be pre-installed in cabinet (cabinet must be ordered separately). Includes door mounting kit and full extension, soft-closing glides.

Width 3/4" | Height 34-1/2" | Depth 24-7/8"

Base end panel that is finished on two sides and edge-banded on all four edges.

Width 3" | Height 84" | Depth 24-7/8"

Tall column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 90" | Depth 24-7/8"

Tall column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 96" | Depth 24-7/8"

Tall column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 34-1/2" | Depth 24-7/8"

Base column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 34-1/2" | Depth 24-7/8"

Appliance end panel with a 3" return which consists of a filler interlocked with a 1/2" plywood return panel. The exposed sides will have near-flush finished ends. The front can be trimmed down to 1" wide if necessary (edge banding may be needed in order to finish the cut edge). The sides will be flush and finished and all four edges are edge-banded.

Width 6" | Height 34-1/2" | Depth 24-7/8"

Appliance end panel with a 3" return which consists of a filler interlocked with a 1/2" plywood return panel. The exposed sides will have near-flush finished ends. The front can be trimmed down to 1" wide if necessary (edge banding may be needed in order to finish the cut edge). The sides will be flush and finished and all four edges are edge-banded.

Width 33" | Height 30" | Depth 21"

Easy reach corner cabinet that will take up 33" from the corner out, on each wall. It comes with one adjustable shelf and will not have soft close hinges. The cabinet will have a 21" depth for an easier installation, however due to the smaller depth, it must be pulled out 3" off both walls (thus, taking up 24" of wall space on each wall). This gap will not be visible once countertops are installed. Once assembled, the door cannot be reversed, so be sure to specify left or right hinging (as if facing the cabinet). Black, adjustable, plastic furniture feet will also be included which will add 3-3/4" to 5-3/8" to the 30" height.

Width 36" | Height 30" | Depth 21"

Easy reach corner cabinet that will take up 33" from the corner out, on each wall. It comes with one adjustable shelf and will not have soft close hinges. The cabinet will have a 21" depth for an easier installation, however due to the smaller depth, it must be pulled out 3" off both walls (thus, taking up 24" of wall space on each wall). This gap will not be visible once countertops are installed. Once assembled, the door cannot be reversed, so be sure to specify left or right hinging (as if facing the cabinet). Black, adjustable, plastic furniture feet will also be included which will add 3-3/4" to 5-3/8" to the 30" height.

Width 30" | Height 30" | Depth 21"

Farm sink base cabinet. Door heights are 17-7/8". Typically, the farm sink base should be a minimum of 3" wider than the farm sink (for example, a 30" farm sink would need a 33" farm sink base). The front panel is attached with clips for easy removal and install. Once removed, the opening will need to be cut, the maximumum it can be cut is 28-1/2"W x 11-5/8"H, then the panel will be reattached back onto the cabinet. To avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off). Black, adjustable, plastic furniture feet will also be included which will add 3-3/4" to 5-3/8" to the 30" height.

Width 33" | Height 30" | Depth 21"

Farm sink base cabinet. Door heights are 17-7/8" and the height above the doors to the top of the cabinet is 11-7/8". Typically, the farm sink base should be a minimum of 3" wider than the farm sink (for example, a 30" farm sink would need a 33" farm sink base). The front panel is attached with clips for easy removal and install. Once removed, the opening will need to be cut, the maximumum it can be cut is 31-1/2"W x 11-5/8"H, then the panel will be reattached back onto the cabinet. To avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off). Black, adjustable, plastic furniture feet will also be included which will add 3-3/4" to 5-3/8" to the 30" height.