Milan Cafe

Width 96" | Height 4-1/2" | Depth 3/4"

Base board molding that is edge banded on all 4 edges.

Width 3" | Height 30" | Depth 3/4"

Base filler that comes as a flat panel and will not have a toe-kick recessed area on the bottom. It will be finished on two sides and edge-banded on all four edges.

Width 6" | Height 30" | Depth 3/4"

Base filler that comes as a flat panel and will not have a toe-kick recessed area on the bottom. It will be finished on two sides and edge-banded on all four edges.

Width 3" | Height 30" | Depth 3"

Corner filler that can be used instead of a blind corner cabinet. It will fill a gap between two cabinets in a corner, allowing the doors and drawers to still function properly, this will leave a void under the countertop.

Width 3" | Height 36" | Depth 3"

Corner filler that can be used instead of a blind corner cabinet. It will fill a gap between two cabinets in a corner, allowing the doors and drawers to still function properly, this will leave a void under the countertop.

Width 3" | Height 42" | Depth 3"

Corner filler that can be used instead of a blind corner cabinet. It will fill a gap between two cabinets in a corner, allowing the doors and drawers to still function properly, this will leave a void under the countertop.

Width 6" | Height 30" | Depth 3"

Corner filler that can be used instead of a blind corner cabinet. It will fill a gap between two cabinets in a corner, allowing the doors and drawers to still function properly, this will leave a void under the countertop.

Width 6" | Height 36" | Depth 3"

Corner filler that can be used instead of a blind corner cabinet. It will fill a gap between two cabinets in a corner, allowing the doors and drawers to still function properly, this will leave a void under the countertop.

Width 6" | Height 42" | Depth 3"

Corner filler that can be used instead of a blind corner cabinet. It will fill a gap between two cabinets in a corner, allowing the doors and drawers to still function properly, this will leave a void under the countertop.

Width 96" | Height 1-1/2" | Depth 3/4"

Light rail molding that must be used with the starter molding (STRM-8) to be flush with the front of the cabinet doors.

Width 48" | Height 108" | Depth 3/4"

Back panel that has one finished side. All edges and opposite side will be unfinished. There will be no edge banding but edge banding can be ordered and applied on site, if needed.

Width 13-7/8" | Height 96" | Depth 3"

Refrigerator end panel that is finished on both sides and edgebanded on all edges. The panel has a 3" filler attached to the front which will be flush with the sides.