Milan Black Matte

Width 3" | Height 30" | Depth 3/4"

Base filler that comes as a flat panel and will not have a toe-kick recessed area on the bottom. It will be finished on two sides and edge-banded on all four edges.

Width 3" | Height 96" | Depth 3/4"

Tall filler that will be finished on two sides and edge-banded on all four edges.

Width 3" | Height 36" | Depth 3"

Corner filler that can be used instead of a blind corner cabinet. It will fill a gap between two cabinets in a corner, allowing the doors and drawers to still function properly, this will leave a void under the countertop.

Width 3" | Height 42" | Depth 3"

Corner filler that can be used instead of a blind corner cabinet. It will fill a gap between two cabinets in a corner, allowing the doors and drawers to still function properly, this will leave a void under the countertop.

Width 3" | Height 30" | Depth 13-7/8"

Wall column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 36" | Depth 13-7/8"

Wall column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 42" | Depth 13-7/8"

Wall column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 84" | Depth 24-7/8"

Tall column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 90" | Depth 24-7/8"

Tall column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 96" | Depth 24-7/8"

Tall column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 34-1/2" | Depth 24-7/8"

Base column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 3" | Height 30" | Depth 13-7/8"

Wall end panel with a filler attached to the front that will be finished on two sides and edge-banded on all four edges. The filler on the front will be flush with the side and can be cut down if needed. If it is cut, to avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off).