Midtown Timber Shaker

Width 13-3/4" | Height 16" | Depth 21"

Trash pull-out for a 18" or 21" base cabinet (two 29 quart waste baskets included). Trash pullout will be a natural finish and will not be pre-installed in cabinet (cabinet must be ordered separately). Includes door mounting kit and full extension, soft-closing glides.

Width 96" | Height 6" | Depth .75"

Molding extension that is used with starter molding (SKU: STRM-8) to make it easier to install molding on the tops of cabinets. The molding extension can be used without the starter molding, but it would first need a cleat support installed on site.

Width 96" | Height 6" | Depth .75"

Shiplap interlocking molding commonly used for walls, backsplash, or the backs of islands and peninsulas.

Width 30" | Height 6" | Depth 12"

Organizer cabinet with wood veneer edge banding and a finished interior. There will be 2 horizontal shelving areas on the left which measure approximately 11-1/8"W x 2"H, and 3 vertical storage areas on the right which measure approximately 5-1/4"W x 4-3/4"H.

Width 30" | Height 5" | Depth 21"

Vanity knee drawer that can be trimmed up to 24" if needed. The drawer front is 23-1/2" wide, then there will be 3-1/4" of trimmable space on either side of the drawer front. The interior height of the drawer is 2-1/2". It has side mounted, ball-bearing slides (not soft close).

Width 30" | Height 6" | Depth 12"

Organizer cabinet with wood veneer edge banding and a finished interior. There will be 2 horizontal shelving areas on either end which measure approximately 11-1/8"W x 2"H, and 2 vertical storage areas in the middle which measure approximately 5-1/4"W x 4-3/4"H.

Width 7/8" | Height 5" | Depth 7/8"

Toe kick cap made from solid wood that will match the finish of the collection. It is used to finish the exposed side of the toe kick end and will need to be cut on site, prior to installation.