Midtown Timber Shaker

Width 13-3/4" | Height 16" | Depth 21"

Trash pull-out for a 18" or 21" base cabinet (two 29 quart waste baskets included). Trash pullout will be a natural finish and will not be pre-installed in cabinet (cabinet must be ordered separately). Includes door mounting kit and full extension, soft-closing glides.

Width 96" | Height .75" | Depth 2.5"

Stacking molding to be used as a decorative piece between cabinets that are getting stacked one above the other. This hides the 'cabinet seam' that you would normally see without a decorative molding in between or applied over the seam.

Width 96" | Height .75" | Depth 1.5"

Starter molding that is installed above wall and tall cabinets which acts as a cleat for a molding extension (SKU: MEX-8), to make it easier to mount moldings on top of the cabinets. The starter molding and molding extension are ideal to use when mounting crown molding all the way to the ceiling.

Width 96" | Height 5.25" | Depth .625"

Base board molding. Please note this base molding is slightly taller to account for uneven flooring and may need to have the height cut if needed, on site.

Width 96" | Height .75" | Depth .75"

Inside corner molding.

Width 96" | Height .75" | Depth 1.5"

Light rail molding, overall depth is 1-1/2", the flat part that will install under the wall cabinets is 3/4" deep. The lip that will extend over the front of the wall cabinet is 1/4" high.

Width 96" | Height .75" | Depth .75"

Quarter round molding.

Width 96" | Height .75" | Depth .75"

Outside corner molding. Inside height and depth is 5/8".