Vienna Timber

Width 96" | Height .75" | Depth 1.5"

Light rail molding, overall depth is 1-1/2", the flat part that will install under the wall cabinets is 3/4" deep. The lip that will extend over the front of the wall cabinet is 1/4" high.

Width 96" | Height .75" | Depth 1.5"

Starter molding that is installed above wall and tall cabinets which acts as a cleat for a molding extension (SKU: MEX-8), to make it easier to mount moldings on top of the cabinets. The starter molding and molding extension are ideal to use when mounting crown molding all the way to the ceiling.

Width 96" | Height .75" | Depth .75"

Outside corner molding. Inside height and depth is 5/8".

Width 96" | Height .75" | Depth .75"

Inside corner molding.

Width 96" | Height .75" | Depth .75"

Quarter round molding.

Width 96" | Height .75" | Depth 2.5"

Stacking molding to be used as a decorative piece between cabinets that are getting stacked one above the other. This hides the 'cabinet seam' that you would normally see without a decorative molding in between or applied over the seam.

Width 30" | Height 5" | Depth 21"

Vanity knee drawer that can be trimmed up to 24" if needed. The drawer front is 23-1/2" wide, then there will be 3-1/4" of trimmable space on either side of the drawer front. The interior height of the drawer is 2-1/2". It has side mounted, ball-bearing slides (not soft close).

Width 7/8" | Height 5" | Depth 7/8"

Toe kick cap made from solid wood that will match the finish of the collection. It is used to finish the exposed side of the toe kick end and will need to be cut on site, prior to installation.