Milan Hazel

Width 3" | Height 36" | Depth 3"

Corner filler that can be used instead of a blind corner cabinet. It will fill a gap between two cabinets in a corner, allowing the doors and drawers to still function properly, this will leave a void under the countertop.

Width 3" | Height 36" | Depth 13-7/8"

Wall column that can be trimmed on site if needed. The sides will be flush and finished, and the back will be unfinished.

Width 30" | Height 36" | Depth 21"

Microwave wall cabinet that has (2) 14-7/8" high doors on top. The front panel is attached with clips for easy removal and install. Once removed, the opening will need to be cut, the maximum it can be cut is 28-1/2"W x 19-3/4"H, then the panel will be reattached back onto the cabinet. To avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off). *Design note: if wainscot panels are applied to the left and right of this cabinet, since they are 3/4" thick, they should also be applied to both sides of the range space, to keep the dimensions aligned. **Note this cabinet has a 21" depth**

Width 30" | Height 36" | Depth 13"

2 door wall cabinet that has 2 adjustable shelves.

Width 30" | Height 36" | Depth 13"

Wall blind cabinet with 2 adjustable shelves. It can be installed right against the corner or pulled a maximum of 3" from the corner which would take up a total of 33" of wall space. Door width is 14-7/8" and the blind side has a fixed panel which is 14-15/16" wide. A filler must be used between the blind and the adjacent cabinet so the doors are able to open without interference. The filler must be purchased separately.

Width 3" | Height 36" | Depth 13-7/8"

Wall end panel with a filler attached to the front that will be finished on two sides and edge-banded on all four edges. The filler on the front will be flush with the side and can be cut down if needed. If it is cut, to avoid damage to the frame and side panels, please apply extra care when cutting the front panel, blue masking tape is the most commonly used to avoid splintering (strong adhesives must be avoided to avoid pulling the finish off).

Width 3" | Height 36" | Depth 3/4"

Wall filler that will be finished on two sides and edge-banded on all four edges.